Things I also had to consider included; placement, how well blended in it would be, airflow around the generator, weatherproofing and exhaust gases.
This unit is designed to be wired into the fuse box of the house, I hired an electrician to do this part and put the input power outlet near where I was putting the box. Its on the beam in the corner behind the box, you may see it in some pics.
The end result is as per the attached picture.
Stuff you will need:
Cement, sand, aggregate and water
wheelbarrow or cement mixer
concrete smoothing device such as trowel and piece of wood
something to hold the form-work, stakes, pegs etc
blocks to make walls
wood of some sort to make door and roof
ventilation type fans
earthing rod (available from electrical supplies shops)
some cable to wire to the earth
Dust mask - cement powder can be a little nasty
Gloves - again with the cement powder, I didnt use them, but I had a hose and washed off anything that got on me
Water - needed for the concrete mix, but also good to replace fluids as you work
Tarp - shade, rain protection etc
First up, choose a site. I had this little corner near the house that was the furthest point from both our house and the next door neighbours. It was also sheltered a little under the eave of the house. It also had no plants of note (save for an elephant ear plant that was nice and easy to cut down), and was kind of neglected. Perfect!
Next, measure up the generator. It was 800mm x 600mm. So that gives a nice easy rectangle to work with. I drew this as on paper so that Id have the measurements all the way through. After that I figured that 100mm of gap between the generator and wall sounded like enough, so added that and drew another box. Finally, after a quick trip to the place that makes concrete blocks, I picked a block type that was 90mm wide. So I added a final box around that. Sadly I seem to have thrown this piece of paper out, so imagine three drawn boxes on a piece of paper with the dimensions scribbled in. these dimensions will vary depending on the size of bricks you choose and the size of your generator.
This then gives the dimensions of the slab that will be required. Make sure that it will fit in the area you want to put it.
I went with enough bricks to make the box about a metre high. In the plan I also included a layer of half height blocks sideways at the bottom to allow for airflow intake with the plan being to have the top exhausting air to give a positive airflow path that should keep the temperature down and also vent the exhaust gases safely into the atmosphere.
*** Edit*** Found the plans! Attached as per pictures 3-6. Photos only Im afraid, but they are easy enough to read :)