Introduction: Etching

Picture of Etching

Step 1: Things Required

Picture of Things Required

1. Copper clad
2. Etching solution (30%hcl and 6%h2o2)
3. Correction pen
4. Nail polish remover

Step 2: Preparing the Etching Solution

Picture of Preparing the Etching Solution

Mix HCl acid (hydrochloric acid )and H2o2 (hydrogen peroxide ) in 4:1 ratio.
AND THIS IS ALL U NEED .

*NOTE - the concentration of reactions and the mix ratio can have a varied range . These are just the values which I prefer.

Step 3: Making Circuit

Picture of Making Circuit

Draw your circuit on copper clad with the help of correction pen

Step 4: Method

Picture of Method

After drawing the circuit place it in the solution wait for 2 to 3 hours the solution will turn green from transparent

........
Take out the circuit wash it with water clean the water with dry cloth rub the pen ink with nail polish remover and your circuit will be ready

Comments

rz1997 (author)2015-06-12

Excellent method .. I found out that even white vinegar works in place of hcl acid. Thanks!

seamster (author)2015-06-12

This etching method looks pretty simple, thanks!

About This Instructable

642views

11favorites

License:

Bio: I am panda pie
More by KahaanZ:Etching
Add instructable to: