Print PDF
Favorite
Email
Step 5SHOULDERS AND WAIST
The shoulders are pretty well shaped by the time you finish the head.
The next major feature is the waist.
I set calipers to the largest diameter, then cut the entire waist to this diameter using an exacto knife and checking with the calipers.
Then remark the smallest diameter and make a norrow cut the the correct diameter, again checking with calipers.
Now connect the cuts in a smooth curve. For this cut I used sandpaper on a stick. (the next step shows this in detail).
Finally lightly sand the waist to a smooth finish, all while checking against the pattersn.
The next major feature is the waist.
I set calipers to the largest diameter, then cut the entire waist to this diameter using an exacto knife and checking with the calipers.
Then remark the smallest diameter and make a norrow cut the the correct diameter, again checking with calipers.
Now connect the cuts in a smooth curve. For this cut I used sandpaper on a stick. (the next step shows this in detail).
Finally lightly sand the waist to a smooth finish, all while checking against the pattersn.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
