Introduction: FPGA-CAFE Stool
made only from 2.5mm MDF
Step 1: Cut
use laser cutter
isu.pdf
- big circle * 13 pieces
- small circle * 2 pieces
isu2.pdf
- top,bottom * 4 pieces
isu3.pdf
- legs * 18 pieces
Step 2: Set Up Main Frame
use big circle and leg
very hard step!
need 2 or more people and hammer
Step 3: Set Up Top and Bottom
use small circle and top,bottom
need hammer too
Step 4: Finish
Share
Recommendations

We have a be nice policy.
Please be positive and constructive.
3 Comments
Is it a stool, or a table?
i think i made a stool, but use as side-table at FPGA-CAFE.
Ah, I see.