Introduction: Famous LM35 With Mediatek Linkit One Board

Picture of Famous LM35 With Mediatek Linkit One Board

In this Instructable you will be able to Interface famous Lm35 with Mediatek LinkitOne Board.

The LM35 series are precision integrated-circuit
1• Calibrated Directly in Celsius (Centigrade) temperature devices with an output voltage linearly- • Linear + 10-mV/°C Scale Factor proportional to the Centigrade temperature. The • 0.5°C Ensured Accuracy (at 25°C) LM35 device has an advantage over linear • Rated for Full −55°C to 150°C Range temperature sensors calibrated in Kelvin, as the user is not required to subtract a large constant voltage • Suitable for Remote Applications from the output to obtain convenient Centigrade • Low-Cost Due to Wafer-Level Trimming scaling.

Step 1: Requirements

Picture of Requirements

  • LM35 Temp Sensor
  • Linkit One Board
  • Connecting wires
  • Usb cable

Step 2: Connections

Vcc : 3V3 on Board


Out: A0 on Board

GND :Ground

Step 3: Code,compile and Run

Picture of Code,compile and Run

Upload The Code And You are Ready To go!!!!! Congratulations You have successfully interfaced LM35 with the Famous Mediatek Linkit One Board.

Have Fun!!!!!

Comments

About This Instructable

246views

4favorites

License:

More by Got007:Accelerometer Interfacing With Mediatek Linkit One  BoardFamous LM35 With Mediatek Linkit One BoardInterfacing Proximity Sensor With Mediatek Linkit One Board
Add instructable to: