Faroun Savonius Wind Turbine

Step 11 Magnet PLacement

Wooow...what a job!! ....that was the most tough thing to do.. with N50 mags...all i can say be carefull and patient.

it took me 2 days to place 24 mags on the disk, some said if it was steel disck it would have been esier.

anyway, i used GB weld to glue them down and then i put 2 part epoxy all arround for extra hold. and later in the project i will cover them HALF way in bostik or resin.

faroun

Comments

[Fik]

How did you keep the magnets to stick to (or fly away from) the previosly glued magnet at its side? Did you use some sort of non-magnetic mold or guide to hold each magnet while the glue cured?

[faroun]

i used the JB weld to stick them on. I used spacer between the magnets while they were drying, you have to keep an eye on them because while they are drying, they may shift a bit so you need to keep them in line, the spacer help or make an aluminum template.

regrads

sam