Print PDF
Favorite
Email
Step 3Begin adding ID cards
After deciding on a design for the hood (I modeled it after armour), begin attaching ID cards.
To give the hood a pixilated look of "flowing" pixels, I started with the bottom of the hood and layered them up. This is optional and involves drilling holes in the cards then attaching them with tiny wire.
For the rest of the suit:
cut ID cards in half, so that they were more movable and squared off.
Hot glue them on to the rest of the body.
I also used packing paper on the inside, so as not to glue the front and back together
To give the hood a pixilated look of "flowing" pixels, I started with the bottom of the hood and layered them up. This is optional and involves drilling holes in the cards then attaching them with tiny wire.
For the rest of the suit:
cut ID cards in half, so that they were more movable and squared off.
Hot glue them on to the rest of the body.
I also used packing paper on the inside, so as not to glue the front and back together
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
