Many of you have reported being burned, scarred, hurt etc. I've made these, and tested them with different fluids. I will show you in detail how to make these, explain how they work, and share my notes on the best kind of flammable fluid to use.
This trick is really fun to perform, and a great way to reuse an old t-shirt. It is still fire, though, so be careful! If you want to know the science behind it, check out step two.
Step 1: Supplies
100% cotton t-shirt or fabric
100% cotton thread - make sure it's thick enough to hold the ball of cotton together, but not so thick that it won't fit through your needle
Needle with eye big enough to fit the thread you are using
Some kind of flammable liquid (details on this in step 8)
Not much, huh? Make sure everything is all cotton. See the next step for reasons why. Skip to step 3 to get straight to work.
Step 2: Why Cotton? Won't it Burn Me?
You need to use all cotton because it doesn't melt. If you have polyester, your fireball will melt in your hand, which will hurt very badly. Cotton can burn, but it doesn't melt.
How does this work?
If you've seen the video, you can see that there is a blue flame at the bottom that turns orange as it goes up. The large surface area of your hand combined with constant movement makes it so it doesn't burn you.
If you hold it in one spot, however, it WILL burn you. That is something the video does not explain. It is still fire, after all. The thing is, the flame where you are holding it is just cool enough to hold it comfortably.
Shouldn't the Cotton Burn?
It would if not soaked with fuel. Kind of ironic, really. When you light these, it is not burning the fuel directly but the gasses from it. The heat makes more fuel turn to gas, which gets burned. It's a cycle that repeats itself as long as there is fuel to vaporize.
Step 3: Clippin' Cotton
Roll it into a ball. No special technique here, just try to make as few "loose ends" as possible. I have found, however, that a super-tight ball does not soak up fluid as well, and does not stay lit as long. Don't make the ball too tight, but not so loose that it's falling apart.
Step 4: Mr. Needle, Meet Mrs. Thread
Step 5: Stuck With A Needle
Pull the thread all the way through, until you get to the knot. Trim the extra thread before the knot.
Step 6: Hardcore (W)Rap
Keep the needle on the thread, and when you have a few inches left, stop.
Then stick the needle through the ball again. Don't take it off the thread yet, though.
Step 7: Time to get Knotty (Naughty?)
You then have the finished fireball! Usually, they're about 1-1.5 inches in diameter. I haven't tried any bigger or smaller.
Step 8: Light 'er Up
Rubbing Alcohol - 70%
This is a good fuel for starters, but any lower percent won't work much at all. 70% rubbing alcohol burns with a decent flame, and not too hot either. It's great to get up your courage, and moderately impressive. You get an ok burn time with this, about 1 1/2 minutes.
Isopropyl Alcohol - 91%
This is only 9% water, meaning it burns much hotter than 70%. The result is a much bigger flame, which is obviously much more impressive-looking. This is a great option, burning at a heat just low enough to hold in one spot for a couple seconds. Recommended for those who are a bit more daring. Burns for about 3 mins.
Zippo Lighter Fluid
DO NOT use this. It burns way too quickly and hot. This stuff is meant to produce a hot flame, and it does. You will be burned if you use this, with not much bigger flame than isopropyl alcohol.
I would say only experts should use this. It's very hot, but has a huge flame that is just plain awesome. I've heard some kinds don't work, like grill lighter fluid. Get the charcoal kind.
Yes, the body spray. It's very impractical to use this. You'd have to spray a ton into a jar just to get enough to soak your fireball in. I'm not sure how well this would burn, however, if at all. I've never heard reports of this being used, so I really can't say. Try it and tell me about it.
I did a comparison between 70% and 91%, and the results are quite dramatic. Check the pictures.
Step 9: Burn, Baby, Burn
Once you think your fireball has enough liquid in it, squeeze it just a bit to make sure there isn't any fluid that will get on your hands and light them up.
Dry your hands off, then light it.
Neat, huh? Here are a couple shots of the 91% in my hand. It's really cool to look at. :P Please be careful and have fun! This is still fire, after all. It's quite easy to drop this and catch your sock on fire. (And I would know.)
If you just can't take the heat, check the next step for tips on not getting hurt.
Step 10: Too Hot? Try These Tips
- Get your hands wet. The extra water takes away some of the heat energy, so it's not as hot.
- Add just a little water to the rubbing alcohol.
- Most of the pain is mental. Convince yourself that it's not actually as hot as it looks.
- Keep it moving! If it stays in one spot, it will burn you.
- Use lower percent rubbing alcohol (not under 70%, though)
- If you really need to, you can use leather gloves, but that kind of takes away the coolness factor.
It'll also help if your hands are naturally callused. That is, the skin is harder and "tougher" that the average person's. It'll probably hurt more if you're a lady, because your hands are probably softer.
Be safe and have fun! Please tell me your experiences with other flammable fluids so I may add the to the list. I'll try to take some night shots sometime soon.