Introduction: Fish Can

Picture of Fish Can

Components :

1 LED

1 Piezo with cables (d = 20 mm )

1 Film can with lid

1 Glass murmuring (d = 16 mm)

2 Wobbly eyes

1 Piece of paper (xx mm x xx mm)

1 x Adhesive tape 105 mm x 50 mm

2 x Adhesive tape 40 mm x 50 mm

1 x Adhesive tape 10 mm x 70 mm

Step 1:

Picture of

1. Solder LED and Piezo element together

Make sure that only one LED leg is connected to one end of the cable.

Step 2:

Picture of

2. Put the marble in the film can and close it

Step 3:

Picture of

3. Wrap the lid of the can with adhesive tape and turn it over like a candy

Step 4:

Picture of

4. Place candy end between two adhesive tape sticks and cut tail fin out of it

Step 5:

Picture of

5. Cut the teeth out of paper

Step 6:

Picture of

6. Prepare teeth and Piezo element

6.a) Tap teeth with a narrow strip of tap in the middle and pick up.

6.b) Touch and pick up the Piezo.

Stick both behind and to the end of the film can.

Pay attention to the alignment of tail fin to LED.

Step 7:

Picture of

7. Paste the eyes and....

Step 8:

Picture of

Shake it.

Comments

Swansong (author)2017-11-27

That's really cute :)

About This Instructable

644views

5favorites

License:

Bio: Technische Sammlungen Dresden / Technology Collections of Dresden A landmark building and outstanding example of industrial architecture in Dresden will soon be home to the city ... More »
More by TechnischeSammlungenDresden:Fish can
Add instructable to: