Print PDF
Favorite
Email
Step 3Make the ignition source
Using the Benzomatic handheld blow torch, the zip strips, scissors, and the wrist guard create a ignition source for the handheld flamethrower.
1. Unscrew all the screws on the side of thlow torch and open it carefully so none of the parts fall out.
2. Remove the metal safety on the trigger, and close the torch back up. This will allow for easier one handed operation.
3. Cut the handguard in half as shown in the picture. Cut away part of it that goes over the palm side of your hands and wrists. I left the circle for the thumb still on so it will fit more securely.
4. Using at least 3 zip-strips attatch the torch to the wrist guard. Put the strips through holes you punch with the scissors on either side of the plastic protector piece.
1. Unscrew all the screws on the side of thlow torch and open it carefully so none of the parts fall out.
2. Remove the metal safety on the trigger, and close the torch back up. This will allow for easier one handed operation.
3. Cut the handguard in half as shown in the picture. Cut away part of it that goes over the palm side of your hands and wrists. I left the circle for the thumb still on so it will fit more securely.
4. Using at least 3 zip-strips attatch the torch to the wrist guard. Put the strips through holes you punch with the scissors on either side of the plastic protector piece.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
