Print PDF
Favorite
Email
Step 6Assemble all the pieces
Put all the pieces together and get ready to fill the tank with flammable liquid.
1. Put the can of air on your belt wherever it feels the most comfortable with the length of hose you used.
2. Fill the bottle 3/4th full with water for a test run.
3. Screw the hose onto the bottle by holding cap in your hand and either rotating the bottle underneath it or carefully spinning the cap down onto the bottle until it is secure.
4. Strap the handheld torch to the underside of your wrist (when holding arm out palm upwards)
5. Connect the plastic bottle to the holder, lock it in, and strap the holder to your wrist.
6. Go to a place you can shoot water, take the open end of the hose and press it down onto the top of the canned air for a second. You shouldent hold it down for more then a second because too much pressure might build up and it could pop off, however after you press it down for a second you still might need to keep your hand on it so it dosent pop off.
7. Press down on the 2 finger trigger, water should stream out about 14 feet.
8. (Works best in dark place where it is easy to see the jet flame from the torch)Light and lock the torch. Adjust it to the maxium flame setting. Press back down on hose to recharge the bottle. Press down with your 2 fingers to shoot out another stream of water, only this time check to make sure it is passing through the flame. If the water passes through the flame it means that it will ignite when you are using a flammable liquid, if not you need to adjust the blow torch on your wrist so the stream of liquid will pass through it.
1. Put the can of air on your belt wherever it feels the most comfortable with the length of hose you used.
2. Fill the bottle 3/4th full with water for a test run.
3. Screw the hose onto the bottle by holding cap in your hand and either rotating the bottle underneath it or carefully spinning the cap down onto the bottle until it is secure.
4. Strap the handheld torch to the underside of your wrist (when holding arm out palm upwards)
5. Connect the plastic bottle to the holder, lock it in, and strap the holder to your wrist.
6. Go to a place you can shoot water, take the open end of the hose and press it down onto the top of the canned air for a second. You shouldent hold it down for more then a second because too much pressure might build up and it could pop off, however after you press it down for a second you still might need to keep your hand on it so it dosent pop off.
7. Press down on the 2 finger trigger, water should stream out about 14 feet.
8. (Works best in dark place where it is easy to see the jet flame from the torch)Light and lock the torch. Adjust it to the maxium flame setting. Press back down on hose to recharge the bottle. Press down with your 2 fingers to shoot out another stream of water, only this time check to make sure it is passing through the flame. If the water passes through the flame it means that it will ignite when you are using a flammable liquid, if not you need to adjust the blow torch on your wrist so the stream of liquid will pass through it.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
