The ultimate in Geek ornamentation.

I was trying to achieve the look of the one pictured at this link, but was having difficulties with the tools and supplies I had.

**Signing Up**

## Step 1: Tools, equipment, supplies and componants

For the Big outer box, I used an almost cube shaped baseball or trinket display case I bought at a craft supply store.

For the smaller box, I could not find something suitable, so I made one using he corners cut out of a clear rectangular box (cuboid) and clear glued back together.

Other thing the boxes and glue, I used:

One 9v battery clip,

one 110 ohm resistor,

one small on/off switch,

2 lengths of magnet (coil) wire,

3 LEDs (one was a self blinking type)

hot glue (and so a hot glue gun is appropriate also),

a soldering iron and some solder,

some conductive glue (although you can also run the magnet wire along edges and paint a gold color to hide it)

A compass (no, not the kind that points north, the kind used to draw arcs and circles),

OR a protractor,

The formula for figuring out the length of the "connecting legs"

and a LOT of patience. Of course, if you have worked with hot glue before, you probably

already have some of that.

The formula is courtesy of BrittLiv and Kelseymh. It depicts the square root of 3 divided by 2 * (b - a)

Or as explained by Kelseymh:

**sqrt(3)**

------- * (b - a)

2

------- * (b - a)

2

which is pretty standard mathematical notation.

Hypercube.^{2}Interesting, do you think you could scale-up to this?

L

It was hard enough concealing magnet wires to make the LED's appear to float (as you can see, I did not achieve the effect with the Red flasher).