Instructables

Flat-pack Chair Model (Using a Laser Cutter)

Step 5: Putting it Together

Picture of Putting it Together
P1040567.JPG
P1040568.JPG
P1040569.JPG
P1040572.JPG
This resulted in lots of little pieces of the chair that had black charred edges from the laser.  Then I just had to put all the pieces together.  I used wire to do so.

First, I bent the end of the piece of wire with small pliers so that the piece wouldn't fall off the end of the wire and so that I would not poke myself.  Between each large piece of the chair I put one of the donut shaped pieces that I cut out so that it would create slots.

 
Remove these adsRemove these ads by Signing Up