Instructables

Flip Mino HD (relatively ) Cheap Water resistant housing

Step 2: Measure 1, 2, 3 times.....THEN drill.......

First, measure from the bottom of the camera to the middle of the lens (since the Mino HD doesn't have a very wide angle lens you don't have to be too terribly accurate when measuring). Mark it. Then grab your 1" drill bit and drill a hole where you would like the lens (you don't have much choice). After that, Dremel off the burrs and finish up the hole.
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!