Introduction: Floor Mat

Picture of Floor Mat

Bath mat with flare!

Step 1: Tapes Used

Red tape cut into 2.5 foot strips laid edge over edge to create a 2.5 foot by 2 foot sheet. Lay first tape sheet non adhesive side down and layer second side - adhesive side to adhesive side the same as the first side.

Silver tape and black tape used to create pattern.

Step 2: Adding Pattern

Cut squares of silver tape the width of the silver tape. Then cut out inverse corners and add a half inch square black piece to the center of the silver block. Create 20 of these blocks to create 5 lines of 4 on the red mat.


Swansong (author)2017-02-14

That's a neat design :) Did you take any progress photos while you were making it?

Oditoadie (author)Swansong2017-02-14

Thank you for asking! Unfortunately this was one of my students that I did this for and she did not offer me photos of her work along the way.

About This Instructable




Bio: Currently I am teaching middle school art, but have also raised sheep and ridden horses on the A show circuit on the East coast.
More by Oditoadie:Carding FiberThe SunSponge Bob
Add instructable to: