Print PDF
Favorite
Email
Step 2Preparing the plexiglass
***What you'll need for this step***
>Plexiglass
>Marker
>Drill
---First place the plexiglass piece over the hole and trace a line
around the edge, making sure to mark 1 cm extra. I made special
'extrusions' where i would drill a hole for screws to go
through later on.
---Then cut carefully along the line(be careful not to keep the
sawblade in one place for too long, as it has a tendency to
melt the plasic.
And now the plexiglass 'window' is ready.
>Plexiglass
>Marker
>Drill
---First place the plexiglass piece over the hole and trace a line
around the edge, making sure to mark 1 cm extra. I made special
'extrusions' where i would drill a hole for screws to go
through later on.
---Then cut carefully along the line(be careful not to keep the
sawblade in one place for too long, as it has a tendency to
melt the plasic.
And now the plexiglass 'window' is ready.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
