Print PDF
Favorite
Email
Step 6Installation
All you need to do now is fit it into your pc.
Put you floppy drive in like the original, screw it into place
The reed switch is better fixed with glue far away from the had drives
(Make sure you know where it is from the outside!)
I used a USB extension cable taken out through an empty card slot at the rear to attach the hub to the pc.
Some motherboards have pins on the motherboard for extra USB ports check your motherboard user manual. If you do wish to use the pins on the board you will need to remove the USB plug from the USB Floppy or make a cable which comes off the motherboard with a USB socket on the end for your drive.
Put you floppy drive in like the original, screw it into place
The reed switch is better fixed with glue far away from the had drives
(Make sure you know where it is from the outside!)
I used a USB extension cable taken out through an empty card slot at the rear to attach the hub to the pc.
Some motherboards have pins on the motherboard for extra USB ports check your motherboard user manual. If you do wish to use the pins on the board you will need to remove the USB plug from the USB Floppy or make a cable which comes off the motherboard with a USB socket on the end for your drive.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
