Print PDF
Favorite
Email
Step 4Sew it up and add the velcro
11) Take the edge where you only sewed straight across and fold it to meet where the base of the flap end. Pin in place on both sides.
12) Leaving a 4mm hem sew along this edge with a straight stitch, finish the edges with a zigzag stitch.
13) Cut a piece of velcro about 1cm shorter than the edge of the case, sew the rough side of the velcro onto the lining side of the flap, 5mm away from the edge.
14) Tip: To get the fluffy fibers out of the stitches on the front of the case run an un-picker or knitting needle (don't use anything sharp or you'll tear the fur) horizontally along the edge.
15) Put the phone into the case and close the flap, mark the case with a pin where it comes down to.
16) Pin the soft piece of velcro onto the case about 5mm above the marker pin you just placed. Sew the velcro in place
12) Leaving a 4mm hem sew along this edge with a straight stitch, finish the edges with a zigzag stitch.
13) Cut a piece of velcro about 1cm shorter than the edge of the case, sew the rough side of the velcro onto the lining side of the flap, 5mm away from the edge.
14) Tip: To get the fluffy fibers out of the stitches on the front of the case run an un-picker or knitting needle (don't use anything sharp or you'll tear the fur) horizontally along the edge.
15) Put the phone into the case and close the flap, mark the case with a pin where it comes down to.
16) Pin the soft piece of velcro onto the case about 5mm above the marker pin you just placed. Sew the velcro in place
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
