Introduction: Flying Fish Paper Airplane
This is my 1st Instructable so please be nice and hopefully I can explain things good. This plane flies well and its cool looking. please leave comments
Step 1: Step 1
take a piece of 8.5" by 11" piece of paper and fold it in half.
Step 2: Step 2
fold the corner down two the middle then do the same to the other.
Step 3: Step 3
now unfold the folds you just made.
Step 4: Step 4
this is kind of hard but you fold on the lines of the fold you just did.
Step 5: Step 5
now fold the last fold to the center line.
Step 6: Step 6
Now after you did that, fold the fold to the center once more
Step 7: Step 7
now fold the top of the top end to the middle.
Step 8: Step 8
after it looks like that fold the end up two the top. look at the pics
Step 9: Step 9
now flip the plane on the other side (the smooth side)
Step 10: Step 10
fold it in half and fold the wings down.
Step 11: Step 11
Now it gets kind of hard, cut in about 2 inches (see the pics to understand)
Step 12: Step 12
Now we cut from the base of the tail to the cut we just made in a slanted line.
Step 13: Step 13
it should look like this when you look at it from the air. It is pretty much done now.
Step 14: Step 14
now just cut about half an inch and note the pic
Step 15: Step 15
now were almost done, fold the tips of the base wing up.
Step 16: Step 16
LAST STEP!! at the front of the plane, pull the bottom jaw out to give the fish a mouth. and there you go, all done
We have a be nice policy.
Please be positive and constructive.