Foam RC Airplane

Step 4 Making the elevator

Cut out the slots to fit the elevator in the airframe. See photo for locations.
Instead of angle cutting the elevator (#2), cut the stationary piece labeled #1 in the photo at the 30-45 degree angle just as in step 3.

Slide and glue piece 1 into place. Slide part #2 into place and tape the elevator hinge just as described in step 3.

Comments

[ciragan]

if that plane flies, than everything else on earth can do so... no way..

[Madrias357]

It flies because it's very lightweight and has a massive amount of power on the nose.