Introduction: Four Barrel Blowgun

Picture of Four Barrel Blowgun

This is a 5 minute nerf blowgun! It is really fun to have wars with your friends.

Step 1: Step 1: Materials

Picture of Step 1: Materials

-10 feet of 1/2 inch PVC pipe
-2 3-5 inch pieces of 3/4 inch PVC pipe
-2 3/4 inch PVC T's
-1 16 inch long piece of 3/4 inch PVC pipe
-duct tape
-nerf darts, need to be either suction, whistle of Velcro

I cut everything with a PVC cutter

Step 2: Step 2: Make the Barrels

Picture of Step 2: Make the Barrels

Use duct tape to tape all of the barrels together. They should be even at the blowing place and flat.

Step 3: Step 3: Make the Handle

Picture of Step 3: Make the Handle

Attach the T's to the 3/4 inch PVC like so

Step 4: Step 4: Attach

Picture of Step 4: Attach

Tape the handle under the barrels and have fun!!!

Comments

LightningEagle14 (author)2014-12-12

cool design, however you could fill the cracks in between the barrels with something to get a better air seal. I'm guessing that it loses some air in the spaces between the barrels.

bmo1536 (author)2014-08-24

Johnstat00 I considered that but I ran out of time at Home Depot! I am going to start to make plans for one. Maybe one mouth piece that you continuously blow and you spin the gun. Just an idea...

johnstat000 (author)2014-08-24

I wonder If someone could make a blowgun- gatling gun! I mean it would decrease the airseal, but only a little. And it would look cool.

MsSweetSatisfaction (author)2014-08-24

That's a really neat design! I hope you don't get too winded using it. Thanks for sharing!

About This Instructable

877views

12favorites

License:

Bio: Interested in anything that involves sports, outdoor activities, music, dogs. A lot of projects I end up doing are for my parents, but I do ... More »
More by bmo1536:Four Barrel Blowgun
Add instructable to: