Print PDF
Favorite
Email
Step 2Wire Contortionist
Most of this is self explanatory and varies on your desired dimensions, style, etc.
All bends are 90 Degrees unless otherwise provided.
Main Rack
1) Straighten the hanger leaving the hook at the end. (Pic 1)
2) Bend 3" from non-hook end. (Pic 2)
3) Bend 2" from last bend along the same plane. (Pic 2)
4) Bend 1/2" from last bend along the PERPENDICULAR plane. (Pic 3)
5) 10.5" from last bend, bend 1", 1/2", 1" to make the square tail. (Pic 3)
6) Repeat steps 1-4 in reverse order to make the rack symmetrical. (Pic 3)
7) Bend the excess with the hook until it breaks off. (Pics 3, 4)
Support Piece
1) Take the remainder w/hook, (Pic 4)
2) Curl the end into a tight circle. (Pic 5)
All bends are 90 Degrees unless otherwise provided.
Main Rack
1) Straighten the hanger leaving the hook at the end. (Pic 1)
2) Bend 3" from non-hook end. (Pic 2)
3) Bend 2" from last bend along the same plane. (Pic 2)
4) Bend 1/2" from last bend along the PERPENDICULAR plane. (Pic 3)
5) 10.5" from last bend, bend 1", 1/2", 1" to make the square tail. (Pic 3)
6) Repeat steps 1-4 in reverse order to make the rack symmetrical. (Pic 3)
7) Bend the excess with the hook until it breaks off. (Pics 3, 4)
Support Piece
1) Take the remainder w/hook, (Pic 4)
2) Curl the end into a tight circle. (Pic 5)
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
