Print PDF
Favorite
Email
Step 5Prep the surface
It's time to get the floor ready.
Remove the panels from the box and lay them out on top of your work area.
Snap the panels together and square up two sides of the panels to two sides of the pallets.
Next draw a cut line on bottom side of the panels of the over hanging areas.
Now, flip the panels over and use your saw to make the cut on the cut line. All of your panels should come out squared and flush to the edge of the pallet. See the last picture below.
Remove the panels from the box and lay them out on top of your work area.
Snap the panels together and square up two sides of the panels to two sides of the pallets.
Next draw a cut line on bottom side of the panels of the over hanging areas.
Now, flip the panels over and use your saw to make the cut on the cut line. All of your panels should come out squared and flush to the edge of the pallet. See the last picture below.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
