Instructables

Fruit Picker out of stuff you have laying around

Featured

Step 3: Screw this.

PreScrew.JPG
Hatch.JPG
I admit that I hadn't thought this one completely through.  I knew I didn't want the hole for the fruit to dip too low so that the bottle would have as much stability as possible, but I also wanted to have the screws on the lower half of the bottle since the plastic is thicker there.  That means part of the bottle blocking access to the screws, unless you have a very tiny screwdriver...
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!