Print PDF
Favorite
Email
Step 4Drums Better...but not great
I tested the newly minted solder joints and noted a vast improvement but still not quite what I was expecting. Upon closer inspection I noted that the piezo elements were again not fully seated.
Unfortunately there was nothing (in relative proximity) to press against like with the cymbal. Fabrication was in order. I used some flat, thin, kinda springy steel and fabricated 3 spring plates.
I mounted another bit of foamcoare to the apex of the spring, added a spot of tape to prevent shorts across the spring, and mounted the assembly below the piezo element.
Unfortunately there was nothing (in relative proximity) to press against like with the cymbal. Fabrication was in order. I used some flat, thin, kinda springy steel and fabricated 3 spring plates.
I mounted another bit of foamcoare to the apex of the spring, added a spot of tape to prevent shorts across the spring, and mounted the assembly below the piezo element.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
