Introduction: GLOWING FLOWERPOT USING LED!!

Picture of GLOWING FLOWERPOT USING LED!!

DO YOU HAVE A NICE GLASS FLOWER POT LYING IN SOME CORNER OF YOUR HOUSE........THEN ITS TIME TO PIMP IT UP BY GLOWING IT USING LEDS.

Step 1: THINGS NEEDED

Picture of THINGS NEEDED

SO HERE ARE THE FEW BASIC THINGS YOU WILL NEED

1)4*1W LED BULB BOARD OR A 4W LED BULB

2)ADAPTER(12V 1A)

3)HEAT SINK

4)OFCOURSE A FLOWER POT!

THATS IT!!!!!!

Step 2: ATTACH LED TO ADAPTER

Picture of ATTACH LED TO ADAPTER

12V 1A ADAPTER WILL HAVE TO WIRES(RED AND BLACK).

CONNECT RED WIRE TO +VE TERMINAL AND BLACK WIRE TO -VE TERMINAL.

CHECK IF IT WORKS.

Step 3: ATTACH LED TO HEATSINK

Picture of ATTACH LED TO HEATSINK

ATTACH LED TO HEATSINK.

DONT FORGET TO ADD LITTLE BIT OF THERMAL COMPOUND BETWEEN LED BOARD AND HEATSINK.

THEN PLACE LED IN JAR OR POT.

Step 4: ADD DESIRED FLOWERS ON FLOWER POT TO MAKE IT LOOK BEAUTIFUL

Picture of ADD DESIRED FLOWERS ON FLOWER POT TO MAKE IT LOOK BEAUTIFUL

Step 5: DONE

Picture of DONE

POWER ON LED AND ENJOY BEAUTIFUL FLOWERPOT AND IMPRESS EVERYONE AROUND.

Comments

Gruntbug (author)2017-11-24

Don't use all capital letters. Please.

Gruntbug (author)2017-11-24

Don't use all capital letters. Please.

DIY Hacks and How Tos (author)2017-11-21

Cool. This would make a really nice mood light.

About This Instructable

331views

0favorites

License:

More by kaustubhc1:GLOWING TREES!!!GLOWING FLOWERPOT USING LED!!MAKE a PROPELLER FROM ICECREAM STICK
Add instructable to: