Step 2: Place resistors and solder
Place the (incredibly tiny!) resistors as shown.
It worked best for me to, one resistor at a time, put some solder flux on the pads for the switches, hold the resistor with the tweezers, solder one side, then solder the other side. Then repeat.
Be careful to use the iron sparingly and be quick, you don't want to burn the resistors.
It worked best for me to, one resistor at a time, put some solder flux on the pads for the switches, hold the resistor with the tweezers, solder one side, then solder the other side. Then repeat.
Be careful to use the iron sparingly and be quick, you don't want to burn the resistors.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
