Step 3: Cut Out the Diagrams...

The first image shows you the diagrams as printed out on large sheets of paper.  The second image shows the diagrams after carefully cutting these out.  Once these are cut out (I used a combination of scissors and matt knife), I was then ready to start using these as guides for cutting out the pieces of corrugated plastic.
<p>that's very good... i want to make it not commercially </p>

About This Instructable




More by delappe:3D Printed Drone Strike Data Installation Laser Etch Rubber Stamps for a Drone Stamp Revolution! Silver Leaf a 3D Print 
Add instructable to: