Print PDF
Favorite
Email
Step 3Put everything in the case
I find it easier to start on a project if I can at least get everything in a case and then begin programming it.
I cut a piece of plexi glass with a dremel stylus for the top so you could see the 4 line lcd.
I chose not to put an RJ45 jack in the box as I couldn't make a neat enough cut with a dremel. So I ran the cat 5 cable through the box and then crimped the plugs after I was done.
I wired the LCD display to pins 0 1 2
The Reed switches to pins 3 4
The pink to pins 13 14
I cut a piece of plexi glass with a dremel stylus for the top so you could see the 4 line lcd.
I chose not to put an RJ45 jack in the box as I couldn't make a neat enough cut with a dremel. So I ran the cat 5 cable through the box and then crimped the plugs after I was done.
I wired the LCD display to pins 0 1 2
The Reed switches to pins 3 4
The pink to pins 13 14
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
