Garden Swing Bench

Published

Introduction: Garden Swing Bench

About: A simple geek with handful ideas and not enough time to make them all happen. So, I'm battling one idea at a time :)

I had that urge again - workshop urge, to go out there and construct something.

And behold - a garden swing bench.

The summer was about to begin and we needed a quiet corner in the garden to sit down in the evening to catch the last glimpses of sun.

------

This project was made based on my personal napkin sketches. I drew inspiration from UK swings manufacturer "Sitting spiritualy" - some fine furniture there.

Made out of pine, impregnated and laquered.

Dimensions: 4 x 15 cms for back support (waaaay too much wood used) . Top is a 4cm × 20 cm plank cut in the middle using a curve and then bottom cuttout is glued on top. Small strips are approx. 4,5×2,5 cms.

Smaller spacer at the bottom, larger at the top for the backrest angles.

Tools: jigsaw, screwdriver, pencil....

----

I do not have the photos of construction, but photos are quite self-explanatory.

Share

    Recommendations

    • Woodworking Contest

      Woodworking Contest
    • Make it Move Contest

      Make it Move Contest
    • Casting Contest

      Casting Contest
    user

    We have a be nice policy.
    Please be positive and constructive.

    Tips

    Questions

    3 Comments

    Other than your backboards being a little short on the left it is a great design,and an excellent job.Well done !!

    1 reply

    Oh, well, live & learn :) . Thanks for kind words.