Print PDF
Favorite
Email
Step 1917
Cut the copper tubing about ½ " longer than the 1/2 " plastic pipe, about 12.5 "
You can solder a barb fitting on the copper pipe for the hose, but keep the length at 12.5 "
Solder the igniter end closed (refer to chart 2). Put a small pin hole in the copper tubing right below the solder.
The black mark is how far the fuel line comes up in the copper air line.
You can solder a barb fitting on the copper pipe for the hose, but keep the length at 12.5 "
Solder the igniter end closed (refer to chart 2). Put a small pin hole in the copper tubing right below the solder.
The black mark is how far the fuel line comes up in the copper air line.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
