Print PDF
Favorite
Email
Step 2523 IMPORTANT !!!
Wipe super glue around the base of the launcher starting at the pipe clamp going up about 1.5" , LET IT DRY then check the fit of the bottle in the glued area. It should fit fairly tight and when tested with air pressure it should come off with about 50 PSI, the idea is to keep the bottle in place while being pressurized to 35 PSI. When it is fired the pressure will well exceed 50 PSI and the bottle will release. DO NOT GLUE THE BOTTLE ON THE PIPE !!!!!!
If the bottle is too tight it may explode when fired. If the bottle does explode, most of the time, it just blows the front of the bottle off with a loud bang. If it fails to fire DO NOT GET IN FRONT OF THE BARREL. Wait a few minutes and unscrew the back and remove the bottle.
If the bottle is too tight it may explode when fired. If the bottle does explode, most of the time, it just blows the front of the bottle off with a loud bang. If it fails to fire DO NOT GET IN FRONT OF THE BARREL. Wait a few minutes and unscrew the back and remove the bottle.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
