Print PDF
Favorite
Email
Step 5Two more holes for rip cuts
You will need to make another hole in the front fence and one in the rear support so one of the angle iron rails can be moved out away from the other and be anchored. This becomes the rip cut position for the rails.
I also made four 1/4 inch spacers from Masonite. They go above the rail supports and below the rails. They provide just a little more clearance for sawing 2 inch stock. Longer screws for mounting the rails are necessary when these spacers are in use.
I also made four 1/4 inch spacers from Masonite. They go above the rail supports and below the rails. They provide just a little more clearance for sawing 2 inch stock. Longer screws for mounting the rails are necessary when these spacers are in use.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
