Instructables
Picture of Ghetto Skate Board Risers.
These are super cheep or free risers, but they do take se time
 
Remove these adsRemove these ads by Signing Up

Step 1: What You Need

1 old bike inner tube X-acto knife Scissors Screw driver

Step 2: Cut The Inner Tube Part 1

Picture of Cut The Inner Tube Part 1
Cut the inner tube so it's one long pice, then cut it in half so it's not a tube any more

Step 3: Take Off Trucks/ Cut Inner Tube Part 2

Picture of Take Off Trucks/ Cut Inner Tube Part 2
Take off your trucks and place them on the inner tube, use an xacto knife to cut along the edges. Do this for however many layers you want, I did 4. Cut little slits where the bolts go, then slide it on (you have to push kind of hard) do this for all the layers until its as thick as you want.

Step 4: Finnish

Picture of Finnish
Put the trucks back on and go test it out, your done!
cortes96 (author) 8 months ago
Google.com
cortes96 (author) 1 year ago
You really don't, I just build stuff when I get board
nwalkup1 year ago
I don't think you really need risers on a penny but this is a good post