Print PDF
Favorite
Email
Step 12Extracting the Wooden LED
Taking the LED out should be simple (if you didn't slather silicone along the base, unlike me). While pealing the mold away from the wooden LED you pull it inside out, so you have to flip it outside in.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Dec 25, 2008. 9:32 AMsgttaz
says:
Mold making would be easier if you use silicone mold from www.micromark.com Get A & B mold rubber and save yourself on the fumes and labor. build a box to house the "BUCK" and pour. cures in 4 hours and release is allot simpler. About $30.00 with shipping. Use over and over ;) Neat project and good write up!
Reply
17
Dec 26, 2008. 4:08 PMguyfrom7up (author)
says:
Thanks, I was going to do this, yet time again was not on my side. I had to go with what I could get from local stores, and I could only get enough just to form a "skin." Thanks for the link, I'll definitely get some so that this won't happen again and stink up my workshop for a week.
Reply
 |
Add Comment
|
