Print PDF
Favorite
Email
Step 16Drill and Glue the Tubes
Drill a (1/8) inch hole (maybe a bit bigger, up to you) near the top of each tube, the wire leading to the LEDs are going to pass through these tubes.
When the wire is fed through, using the thermal glue again, glue the tubes to the base of the aluminum that the LEDs are glued to.
I added more glue later because the original amount wasn't enough to keep it sturdy.
Feed one wire through per tube.
When the wire is fed through, using the thermal glue again, glue the tubes to the base of the aluminum that the LEDs are glued to.
I added more glue later because the original amount wasn't enough to keep it sturdy.
Feed one wire through per tube.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Jun 3, 2009. 9:22 AMeng.germano
says:
What did you use to fill it? What material?
Reply
 |
Add Comment
|
