Print PDF
Favorite
Email
Step 6Turn it Down
Using the Gouge, turn the block of wood into a cylinder. Then use the flat tool (along with the gouge) to make a uniform cylinder that has a diameter of 11cm. If you don't have a caliper, you can use a c clamp with a ruler (that's what I used).
Once turned down, take your ruler and mark off a 14cm section; this will be the overall length of the LED. From the left of that section, mark off 2cm and 10cm.
See picture for what each part is for.
Once turned down, take your ruler and mark off a 14cm section; this will be the overall length of the LED. From the left of that section, mark off 2cm and 10cm.
See picture for what each part is for.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
