Print PDF
Favorite
Email
Step 7Carve it into an LED
First off, do not turn down the 2cm section, this is the lip and it's diameter is 11cm, which the cylinder already is. Using a gouge, bring down the excesses to the smallest diameter that your lathe can handle/you are comfortable with. Next bring down the biggest section to a constant 10cm. Bring down the last, right most section (besides the excess) to 10cm and round it off starting from the end of the 10cm constant and the left mark of the excess. If you are confused, please consult the picture.
When you're done sand it down with some fine grit sandpaper and put some finishing wax on, I'm not sure if it's necessary, I just did.
When you're done sand it down with some fine grit sandpaper and put some finishing wax on, I'm not sure if it's necessary, I just did.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
