Introduction: Giant Party Popper
Hey guys, now I gona show you how I made this really AWESOME giant party popper that can shoot candy, confetti or anything else that fits inside. It is really easy and fun to make even with children.LETS HAVE SOME FUN!!!
Step 1: What You Need
- cardboard roll
- duct tape/electrical tape
- pocket knife
- craft foam ( about 1 inch / 2cm thick )
- hot glue gun
- for powering the popper: pump or air compressor
Step 2: Make the Endcaps
To start grab the foam and draw around the end of the tube two times, than cut out carefully ( it's easier when the knife is hot ). If your foam is too thin tr to glue them together.
Step 3: Make the Endcaps Airtight
To make the endcapes airtight rap them around with tape, if they fit tihgtly in the tube it's perfect.
Step 4: The Last Steps...
To finish you need to punch a hole in one oft the endcaps and glue it to one end of the tube, than insert the pump and load in some goods. LETS HAVE SOME FUN!!!
We have a be nice policy.
Please be positive and constructive.