Giant Tooth-pick

1,729

6

2

Published

Introduction: Giant Tooth-pick

About: I'm a 16 year old balloon twister and I enjoy all aspects of DIY My hobbies include (but are not limited to) robotics, magic, origami, woodworking, electronics, longboarding, blacksmithing, animation, smal...

Is it a bird? Is it a plane no its a... giant tooth-pick????
Yes people its a GIANT tooth-pick?!?!? and ill be showing you how to make it (even though its pretty straight forward)

YOU WILL NEED:
a dowel
a toothpick
a ruler
a pencil
a saw
and sandpaper 

Step 1: Measurements

The first step it to take measurements and decide where to cut your dowel. my tooth-pick was 2 mm in diameter and the dowel was 9mm so the ratio was 1:4.5. my tooth-pick was 66mm long and the tip was 10mm long so the measurements for the Giant tooth-pick came to:
diameter: 9mm
length: 297mm
tip(point at the end): 45mm

Step 2: The Tip

This step is pretty straight forward just remember not to make the tip too long.

Step 3: Finished!

Now clean your gums!

Share

    Recommendations

    • Creative Misuse Contest

      Creative Misuse Contest
    • Oil Contest

      Oil Contest
    • Water Contest

      Water Contest

    2 Discussions

    Looks like a knitting needle!! But very well done!!!Guess who??