Introduction: Glass Board

Picture of Glass Board

always wanted to right the glowing word and have you fantasized about it you have landed on the correct place

Step 1: Materials Required

Picture of Materials Required
  • glass
  • cutter
  • scale
  • battery
  • pencil
  • wire
  • led strip
  • sun board
  • cell
  • glue gun and sticks

Step 2: Making the Base

Picture of Making the Base

cut 5 strips of 1.5 inches broad and length of the glass + 2 cm on both sides make the incision of length of the glass in the center in the 4 of the strips and stick them together and stick the together with the hot glue

Step 3: Final Step

Picture of Final Step

Insert the glass pane into the base and light up the led strip and you are Ready to go


FilipeC36 (author)2017-03-12

But... what aboute the LEDs?? Whow/where did u put?

sanyam jain (author)FilipeC362017-08-30

They were present in the base

dan3008 (author)2017-02-28

simple yet effective :) nicely done :)

sanyam jain (author)dan30082017-03-02

Thank you dan

About This Instructable




Bio: making makes me feel enlightened
More by sanyam jain:Glass BoardSolar System Light in BulbNever Ending Card in 5 Min
Add instructable to: