Print PDF
Favorite
Email
Step 3Adding the phone to the glove
The board was added to the glove by running small bolts up through the leather to match up with the screw holes on the phone circuit board.
The battery was attached by wrapping it in copper wire and threading the wire through the glove leather.
The screen was wrapped in copper wire and then grouped at the base to form a tripod. This was then threaded into the top of the battery.
The buttons were added to the top of the finger sections.
The microphone and speaker were re-soldered to be on long wires, and then attached to the base of the thumb and the end of the pinkie.
The battery was attached by wrapping it in copper wire and threading the wire through the glove leather.
The screen was wrapped in copper wire and then grouped at the base to form a tripod. This was then threaded into the top of the battery.
The buttons were added to the top of the finger sections.
The microphone and speaker were re-soldered to be on long wires, and then attached to the base of the thumb and the end of the pinkie.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
