With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
This instructable will show how to make a glow in the dark clock out of old computer parts.
Tools Required: 1) Hot glue gun 2) Super Glue 3) Drill or dremmel tool
The following are the materials used: 1) Hard Drive 2) RAM 3) CD/DVD 4) Clock Mechanism 5) Small SMD IC chips (Surface Mounted Device Integrated...
The hard drive platters can be removed from any hard drive by removing the screws on the red dots in the image. Drill out the middle of the spindle o...
Mix and match any RAM although I found the 300mhz to give the clock the best performance. Depending on the size of RAM you may need to sand the corn...
You can strip the clock mechanism from an old thrift store / yard sale clock like I did or you can buy just the mechanism You can buy them at any craf...
1) These are easy to de-solder from any PCB board by heating up the opposite side of the board as the chip. I used a heat gun but you could use a li...
Just in case here is a view looking into a computer and shows where you can find each part in red. RAM (left) Integrated onto the motherboard in slot...
1) Cut out battery slot on CD 2) Hot glue Clock Mechanism onto CD. Position battery slot over the cutout spot on the CD 3) Hot glue RAM around the cl...
1) Paint hands white or glow in the dark. 2) Place Glow in the Dark Binary Stickers. Binary 1-12: 1 - 0001 2 - 0010 3 - 0011 4 - 0100 5 - 0101 6 - ...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »