1) This is my first instructable so if i leave something out just ask.
2) I suck at spelling and grammar.
3) Im going to assume that you kinda know how to use tools, and a measuring devise.
4) If I jump around some its because this is just what was done, the order in witch it is done doesn't matter, and I put a part on then took it off to make it easer to add other parts and holes then put it all back together once all the holes are in.
That being said this is my GoPro Pan-N-Tilt radio controlled head, I put it on my EMT conduit jib crane or my track dolly I made(that i hope to integrate in to the RC realm soon)
Where I got my parts:
The aluminum and screws where purchased at Low's
The Servos, ServoBlocks, and Servo Stands where purchased from servocity.com (a kickass web sight for cool stuff)
The Stepper motor case I had laying around
The RC Heli...Well I had a hard time trying to fly it and thought it would be better put to use in some other form... That can't crash
Step 1: Parts
1/16" X 1/2" Angle aluminum
1/16" X 1 1/2" Flat aluminum
1/8" X 1 1/2" Flat aluminum
6 X 32 screws about 1/2"
8 X 32 Screws short about 1/4"
Stepper Motor case, bearings, screws
8 X 32 screw, 3 washers, 2 nylock nuts
Crashed RC helicopter RC parts, radio and battery
One (1) Vertical Aluminum Mount
Two (2) ServoBlocks
Two (2) Servos