Introduction: Graphics on Nokia 5110 Lcd Using Arduino

In this short instructable I am gonna displ some graphics on Nokia 5110 LCD using ARDUINO UNO R3 this is very helpful for beginners`s here is a testing video .

Step 1: MATERIALS REQUIRED

Picture of MATERIALS REQUIRED

  • Nokia 5510 LCD
  • Arduino board
  • Jumper Wires
  • Bread Board

Step 2: MAKE CONNECTIONS

Picture of MAKE CONNECTIONS

Connections are as follows and also shown in schematic .

  • SCK or CLK- Pin 7 arduino
  • MOSI or DIN – Pin 6 arduino
  • DC – Pin 5 arduino
  • RST – Pin 3 arduino
  • CS or CE – Pin 4 arduino
  • VCC – 3.3 volt arduino
  • BL – 5 volt arduino
  • GND- ground of arduino

Step 3: CODE THE ARDUINO

Picture of CODE THE ARDUINO

First download the library from HERE . And after that download code from HERE then program the arduino .

Step 4: RESULT

HOPE YOU`VE ENJOY THIS THANKS FOR READING

Comments

PetrM4 (author)2016-02-24

Can I use whichever display of old mobile phone, or i have to use display of Nokia 5110. I think, if that will work which another display, but which same electronic circuit and same code...?

carlos enriquel (author)2015-09-16

que bien, yo estoy recojiendo todos los celulares dañados para utilizar sus partes, me gustaria mucho utilizar las camaras

lo felicito

About This Instructable

15,463views

251favorites

Bio: Hello I am Tech Creator Akshay I love electronics and get in touch for more projects
More by Akshay Jha:Add Voice to Your Arduino Projects Without Using Any Module(BLINK WITH VOICE)How to Interface Oled and Arduino (Part -1)DIY Helping hand for soldering and elec.(SIMPLE & CHEAP)
Add instructable to: