Print PDF
Favorite
Email
Step 3Prepare/Strip the Wires and Tin
-Locate the wire from the right cymbal, unplug it, and cut it in half.
>You must then carefully strip the wire to reveal the white coated "cymbal +" wire and the bare
copper "cymbal -" wire. Tin the bare wire and the stripped white wire on both both sides of the cut.
-Filp the board over and identify the solder points for the plug that the green drum plugs into. Solder a wire onto the "green drum +" (green colored wire) and the "green drum -" (black colored wire). strip and tin the other end of both of these wires in preparation for the DPDT switch.
>You must then carefully strip the wire to reveal the white coated "cymbal +" wire and the bare
copper "cymbal -" wire. Tin the bare wire and the stripped white wire on both both sides of the cut.
-Filp the board over and identify the solder points for the plug that the green drum plugs into. Solder a wire onto the "green drum +" (green colored wire) and the "green drum -" (black colored wire). strip and tin the other end of both of these wires in preparation for the DPDT switch.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
