With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
I began my addiction to faux drumming on guitar hero world tour. Having recently tried the drum controller on rock band 2 I was less than impressed. I ...
here is a view from the bottom of the controller after you have removed all of the screws (switch is installed here..will get to that shortly).
Next you need to remove the 2 screws securing the small circuit board where all of the drum pads and cymbals plug in.
-Locate the wire from the right cymbal, unplug it, and cut it in half. >You must then carefully strip the wire to reveal the white coated "cymbal +" ...
-Identify where you would like to place the switch and dremel out a hole and drill holes for the mounting screws
Solder the wires onto switch as label in the picture below and the schematic. Be careful to maintain proper orientation of the + and - wires.
-Mount the DPDT switch using the supplied screws and assemble the controller. You can choose to place the switch where ever you like but I was too lazy ...
-Placing the switch to the left position allows the controller to behave normally when playing Guitar Hero.-Sliding the switch to the right position now allows the orange cymbal ...
Join 2 million + to receive instant DIY inspiration in your inbox.
Download our apps!
© 2016 Autodesk, Inc.