Introduction: Guitar Hero and Headphone Holster/holder

By sites.google.com/site/andrewmont

Tired of Piles, hang up those headphones and GH controller and keep them right at your fingertips!

Step 1: Gather Materials and Tools

Materials:
- 3/8" Plywood scrap (around 2 1/2" x 6")
- Spring Clamp

Tools:
- Bandsaw/ Scroll saw
- Tape Measure
- Pencil
- Square (Optional)
- Dremel (Optional)

Step 2: Cut the Holster

Cut the slot that the neck of the Guitar will go in. measure your own, but my x-plorer required a cut that was 1 1/2" by about 2 1/4", but its not rocket science. try to taper it back to make it easier to slide in.

Step 3: Dremel a Recessed Area, Optional

use your sanding tool on a dremel to recess an area for the neck to rest. go to about 1 1/2" from the back of the slot. (bad pic)

Step 4: Add the Clamp

Clamp the holster on your table/ desk or wherever is convenient. place at an angle .

Step 5: Add Your Gear

place the GH guitar in the holster, and put the band of your headphones over the clamp, you may find other uses as well! now your controller and headphones are right at your fingertips! enjoy!