Guitar Pick Holder Just Like in Concerts

This is a simple guitar pick holder, inspired like the ones in concerts; where they place extra picks along the microphone stand boom for easy reach. Well, I don't perform in gigs nor concerts, but I just like how the picks lined up nicely and how easy it is to access them.

This is an easy project and would only take 10 to 15 minutes. To make the holder, you would require the following items :

~ 1 Binder Bar
~ 1 A4 size Foam Board (thin high density foam)
~ Steel ruler
~ Cutter
~ Magic Tape
~ 3 mm diameter rod (fine tread screw, nails etc)

Step 1 Getting Started

Measure 3 cm and cut the foam board along its length using a cutter. You will end up with a strip of 3 cm foam board. The measurement will depend on the size of your binder bar. However in general; when folded in two along its length, the foam board should be wider than the binder bar. Refer to the following steps if not clear.

Comments

[qazwsxedcrfvtgbyhnujmikolp]

"To fou ki sa" To you to translate what's written

[tinmankingkinney]

"the fxck is that?" <-is that what is means?

[fearme36]

uhh... what language.... anyways sweet name dude

[stevie1]

or you could cut the top 3rd of a piece of pvc pipe like this:

[pandaboy292]

cool i am going to make one to put on my dresser

[mfa97]

Thank you all for your kind comments.

[drummonkey92]

awsum i had wondered how to do this for a while n just seeing your parts list made it clear great job!

[khendar]

Nice idea! I don't see what's wrong with the good ol' strip-o-gaff though =)

[acaz93]

Way too cool , Bad thing i don't gig that oftenly ,

[LinuxH4x0r]

Cool! too bad i don't play guitar

[GorillazMiko]

Awesome! The ones they use are actually connected to microphone stands, so just get some double sided tape and connect it to the microphone stand. Nice job! +1 rating. (added to favorites)