Introduction: Guitar Picks From Circuit Board

Picture of Guitar Picks From Circuit Board

Step 1: Materials Needed

Picture of Materials Needed

What you need:
A circuit board (preferably kind of thin)
Snips of some sort (scissors will work if board is thin enough)
A pick template
A file
A pencil

Step 2: Tracing and Cutting

Picture of Tracing and Cutting

Put your pick on your circuit board and trace around it with a pencil or pen, then cut it out with snips or scissors (scissors may not my strong enough).

Step 3: Smoothing

Picture of Smoothing

Grab your file and start filing the edges to make pretty

Step 4: Optional Step. Bringing Out the Copper

Picture of Optional Step. Bringing Out the Copper

If you want to bring out the copper, just sand both sides with sand paper (not too low of a grit), and do that till it's copper and green. I like to do this because it looks purty

Step 5: You're Done!

Picture of You're Done!

I hope you liked this project. Be sure to tell me if I wasn't clear about something. Just remember that these have SMALL amounts of lead in them. So don't eat them. Not that you would, but I'm just saying. It's not a good idea. But there's not enough lead for it to be lethal. These picks are completely safe to use. But don't lick/eat them.

Comments

Yonatan24 (author)2015-11-28

Hi, I've added your project to the "Re-Using Old Circuit Boards (PCB's)" Collection

This is the link If you are interested:

https://www.instructables.com/id/Re-Using-Old-Circu...

About This Instructable

1,251views

64favorites

License:

Bio: I love guitar, and I really regret my username!
More by ShrimpyPlaysMC:Guitar Picks From Circuit BoardGuitar Picks From Cymbals
Add instructable to: